Peugeot 406

since 1996 release

Repair and operation of the car



Peugeot 406
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engine
+ 4. Cooling systems, heating and ventilation
+ 5. Fuel system
+ 6. System of ignition
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Brake system
+ 11. Suspension bracket and steering
- 12. Body
   12.1. General information
   12.2. Care of a body
   12.3. Care of an upholstery and rugs
   12.4. Repair of insignificant damages of a body
   12.5. Repair of strong damages of a body
   12.6. Front bumper
   12.7. Rear bumper
   12.8. Cowl
   12.9. Cowl lock cable
   12:10. Cowl lock
   12:11. Doors
   12:12. Door upholstery
   12:13. Lock and handles of opening of a door
   12:14. Glasses of doors
   12:15. Trunk lid
   12:16. Luggage carrier lock
   12:17. Back door
   12:18. Lock of a back door
   12:19. System of the central blocking
   12:20. Power windows
   12:21. External rear-view mirrors
   12:22. Front and back flew down
   12:23. Hatch
   12:24. Slips and emblems
   12:25. Seats
   12:26. Mechanism of a tension of a seat belt of a front seat
   12:27. Seat belts
   12:28. Finishing of salon
   12:29. Central console
   12:30. Dashboard
+ 13. Electric equipment
+ 14. Main malfunctions


7f75ccd3



12.7. Rear bumper

Removal and installation

PERFORMANCE ORDER
1. On models the sedan (Saloon) from an internal part of the luggage compartment unscrew fastening screws (are specified by shooters a photo at the left) and remove back finishing of a luggage carrier (a photo on the right).
2. Unscrew screws and remove plates of fastening of the left and right angles of finishing of the luggage compartment.
3. Remove fastening percussion caps (take the central pins then take a percussion cap) and release side finishing of a luggage carrier for access to fastening of a bumper.
4. On models of a komba (Estate) open a back door and remove a basic surface from the basis and lateral faces. Unscrew screws and remove a back plate of finishing. Remove the left and right lower side finishing of a luggage carrier. Remove percussion caps of fastening of side finishing of a luggage carrier to a floor. Release brackets of fastening and remove plastic office for storage.
5. On all models unscrew nuts and remove assembly of ventilation from the right back corner of the luggage compartment.
6. From under the car unscrew screws (are specified by shooters) fastenings of a back part of an insert of a wheel to a bumper.
7. Displace inserts from a bumper and unscrew nuts, the fixing left and right ends of a rear bumper to a body.
8. Unscrew bolts of fastening of a rear bumper to a body.
9. In the luggage compartment unscrew 6 nuts of fastening of the top part of a rear bumper.
10. On models the sedan (Saloon) disconnect the electric socket of illumination of registration plate which is located about the left lamp of a backing.
11. Release the ends of a bumper and remove it from the car, releasing the condensing ring of electric wires of illumination of registration plate from a body.
12. Installation is made in the sequence, the return to removal.
On the homepage