Peugeot 406

since 1996 release

Repair and operation of the car



Peugeot 406
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engine
+ 4. Cooling systems, heating and ventilation
+ 5. Fuel system
+ 6. System of ignition
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
- 10. Brake system
   10.1. Technical data
   10.2. Pumping of the hydraulic brake system
   10.3. Brake pipelines and hoses
   10.4. Replacement of front brake shoes
   10.5. Replacement of back brake shoes
   10.6. Replacement of back brake shoes on drum brakes
   10.7. Forward brake disk
   10.8. Back brake disk
   10.9. Back brake drum
   10:10. Support of a forward brake
   10:11. Support of a back wheel
   10:12. Back brake cylinder
   10:13. Main brake cylinder
   10:14. Brake pedal
   10:15. Vacuum amplifier of brakes
   10:16. Unilateral valve of the vacuum amplifier of brakes
   10:17. Adjustment of the emergency brake
   10:18. Lever of the emergency brake
   10:19. Cable of the emergency brake
   10:20. Brake shoes of the emergency brake (model with disk brakes)
   10:21. The valve of adjustment of pressure in the brake system
   10:22. Stoplight switch
   10:23. Anti-blocking system of brakes (ABS)
   10:24. The vacuum pump (cars with the diesel engine)
   10:25. Check of the vacuum pump on cars with diesel engines
+ 11. Suspension bracket and steering
+ 12. Body
+ 13. Electric equipment
+ 14. Main malfunctions


7f75ccd3



10:16. Unilateral valve of the vacuum amplifier of brakes

Removal

PERFORMANCE ORDER
1. Weaken a collar and disconnect a vacuum hose from the unilateral valve of the vacuum amplifier of brakes.
2. Take the valve from rubber ring consolidation, turning it in the parties and sipping on itself.
3. Remove the condensing rubber ring from the vacuum amplifier of brakes.

Check

PERFORMANCE ORDER
1. Check the unilateral valve for existence of damages. The valve can be checked, blowing it in two directions. Air has to pass through the valve only from the vacuum amplifier of brakes.
2. Check the rubber condensing ring and a vacuum hose for wear and damages. If necessary – replace.

Installation

PERFORMANCE ORDER
1. Establish the condensing rubber ring in the vacuum amplifier of brakes.
2. Insert the unilateral valve in the vacuum amplifier. At the same time be careful not to damage the rubber condensing ring.
3. Connect a vacuum hose to the valve and fix it by a collar.
4. Start the engine and check efficiency of the vacuum amplifier of brakes.
On the homepage