Peugeot 406

since 1996 release

Repair and operation of the car



Peugeot 406
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engine
+ 4. Cooling systems, heating and ventilation
+ 5. Fuel system
+ 6. System of ignition
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
- 10. Brake system
   10.1. Technical data
   10.2. Pumping of the hydraulic brake system
   10.3. Brake pipelines and hoses
   10.4. Replacement of front brake shoes
   10.5. Replacement of back brake shoes
   10.6. Replacement of back brake shoes on drum brakes
   10.7. Forward brake disk
   10.8. Back brake disk
   10.9. Back brake drum
   10:10. Support of a forward brake
   10:11. Support of a back wheel
   10:12. Back brake cylinder
   10:13. Main brake cylinder
   10:14. Brake pedal
   10:15. Vacuum amplifier of brakes
   10:16. Unilateral valve of the vacuum amplifier of brakes
   10:17. Adjustment of the emergency brake
   10:18. Lever of the emergency brake
   10:19. Cable of the emergency brake
   10:20. Brake shoes of the emergency brake (model with disk brakes)
   10:21. The valve of adjustment of pressure in the brake system
   10:22. Stoplight switch
   10:23. Anti-blocking system of brakes (ABS)
   10:24. The vacuum pump (cars with the diesel engine)
   10:25. Check of the vacuum pump on cars with diesel engines
+ 11. Suspension bracket and steering
+ 12. Body
+ 13. Electric equipment
+ 14. Main malfunctions


7f75ccd3



10.5. Replacement of back brake shoes

GENERAL INFORMATION

Prevention

Surely you make replacement of all blocks on one axis of the car even if the limit of wear was reached by one block.


PERFORMANCE ORDER
1. Lift a back part of the car and record on supports. Remove back wheels.
2. Remove spring clamps (are specified by shooters), the fixing pins holding brake shoes.
3. Remove the spring preventing vibration of blocks.
4. Using flat-nose pliers, take internal and external brake shoes from a support.
5. Measure thickness of an overlay of each brake shoe.
6. If blocks are suitable for further operation, clear them, using a wire brush and rags.
7. Before installation of blocks check that the directing plugs easily move in a support and rubber protective covers are not damaged.
8. If new brake shoes are established, press the piston into a support a wooden core or the handle of the hammer. At the same time you watch that the piston did not warp, and the surfaces of the piston and a boot were not damaged. At a piston vdviganiye brake fluid is forced out from the brake cylinder in a broad tank therefore constantly watch liquid level in a tank, and if necessary pump out its small amount from a tank.
9. Establish brake shoes in a support.
10. Establish into place the spring preventing vibration of blocks. Establish the pins holding blocks, passing them through an opening in a support, a brake shoe and the center of the spring preventing vibration of blocks. Fix pins by spring clamps.
11. Several times press a brake pedal that brake shoes nestled on a brake disk. Check the level of brake fluid in a tank. Check that the internal ledge of a block was correctly combined with one of support piston grooves.
12. Repeat above-mentioned actions on the second wheel.
13. Establish wheels and lower the car.

14. Check the level of brake fluid.

On the homepage