Peugeot 406

since 1996 release

Repair and operation of the car



Peugeot 406
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engine
+ 4. Cooling systems, heating and ventilation
+ 5. Fuel system
+ 6. System of ignition
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Brake system
- 11. Suspension bracket and steering
   11.1. Technical data
   11.2. Rotary fists
   11.3. Replacement of forward hug bearings
   11.4. The lobby is resistant
   11.5. Repair of a forward rack
   11.6. Lower lever of a forward suspension bracket
   11.7. Lower spherical hinge of a forward suspension bracket
   11.8. Stabilizer of cross stability of a forward suspension bracket
   11.9. Coulisse of the stabilizer of cross stability of a forward suspension bracket
   11:10. Lower frame of a forward suspension bracket
   11:11. Nave of a back wheel
   11:12. Replacement of bearings of a back nave
   11:13. Shock-absorber of a back suspension bracket
   11:14. Cylindrical spring of a back suspension bracket
   11:15. Pin of a nave of a back suspension bracket
   11:16. Lower lever of a back suspension bracket
   11:17. Top lever of a back suspension bracket
   11:18. The directing lever of a back suspension bracket
   11:19. Draft of a back suspension bracket
   11:20. Stabilizer of cross stability of a back suspension bracket
   11:21. Coulisse of the stabilizer of cross stability of a back suspension bracket
   11:22. Steering wheel
   11:23. Steering column
   11:24. Intermediate shaft of a steering column
   11:25. Ignition lock
   11:26. Steering mechanism
   11:27. Replacement of protective covers of the steering mechanism
   11:28. Removal of air from system of steering with the amplifier
   11:29. Pump of the amplifier of steering
   11:30. Spherical hinge of steering draft
   11:31. Steering draft
   11:32. Angles of installation of wheels
+ 12. Body
+ 13. Electric equipment
+ 14. Main malfunctions


7f75ccd3



11:11. Nave of a back wheel

Removal

PERFORMANCE ORDER
1. Remove the back brake drum.
2. By means of the lever remove a protective cap of the central part of a nave of a back wheel.
3. Using the hammer and a punch, unbend the fixing fillet on a nut of fastening of a nave of a back wheel.
4. Unscrew a nut of fastening of a nave.
5. Using a stripper, remove a nave from a pin.
6. Check a condition of the hug bearing. It is recommended to replace hug bearings since at removal of a nave bearings can be damaged.
7. Check a pin for wear or mechanical damages. If necessary replace it.

Installation

PERFORMANCE ORDER
1. Make sure that the bearing is filled with lubricant, grease a pin with a thin layer of engine oil.
2. Install the new bearing on a pin, using the hammer and a tubular mandrel which presses on an internal ring of the bearing.
3. Establish a new nut of a nave.
4. Tighten it the required moment.
5. Using the hammer and a drift, fuller a nut fillet in a nave groove.
6. Install the brake drum.
On the homepage