Peugeot 406

since 1996 release

Repair and operation of the car



Peugeot 406
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engine
   + 3.1. Petrol engines
   - 3.2. Diesel engines
      3.2.1. Technical data
      3.2.2. Check of pressure of compression
      3.2.3. Installation of the mechanism of gas distribution
      3.2.4. Cover of a head of the block of cylinders
      3.2.5. Pulley of a bent shaft
      3.2.6. Casing of a gear belt
      3.2.7. Gear belt
      + 3.2.8. Pulleys of a gear belt
      + 3.2.9. Right engine mount and mechanism of a tension of a gear belt
      3.2.10. The directing roller of a gear belt
      3.2.11. Cam-shaft and pushers
      3.2.12. Check and adjustment of gaps of valves
      + 3.2.13. Removal and installation of a head of the block of cylinders (engines 1.9 liters)
      3.2.14. Removal and installation of the oil pallet
      3.2.15. Removal and installation of the oil pump
      + 3.2.16. Replacement of sealing rings of the crankshaft
   + 3.3. Repair of the engine
+ 4. Cooling systems, heating and ventilation
+ 5. Fuel system
+ 6. System of ignition
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Brake system
+ 11. Suspension bracket and steering
+ 12. Body
+ 13. Electric equipment
+ 14. Main malfunctions


7f75ccd3 erostopersex



3.2.5. Pulley of a bent shaft

Removal

PERFORMANCE ORDER
1. Take off an auxiliary driving belt.
2. For fixing of the crankshaft of the engine from a provorachivaniye the assistant has to include the fourth transfer and press against the stop a foot brake or remove a starter and record a gear wreath of a flywheel (the tool for fixing of a gear flywheel is specified by an arrow). At this time weaken a bolt of fastening of a pulley of the crankshaft. A bolt of fastening of a pulley it is necessary to use always new.
3. Unscrew a bolt and remove a pulley from the crankshaft. If the pulley is established on the sliding landing to the crankshaft with application of a spline or pin, remove them. If a pulley напрессован on the crankshaft, remove it by means of a stripper.

Installation

PERFORMANCE ORDER
1. Establish a segment spline in a flute of the crankshaft and install a pulley on the crankshaft, combining a groove on a pulley with a segment spline.
2. Clear a carving of a bolt of fastening of a pulley and grease it with means against unscrewing (Peugeot recommends Loctite Frenetanche use).
3. Screw up a bolt with a washer of fastening of a pulley.
4. Establish and adjust a tension of an auxiliary driving belt.

On the homepage