Peugeot 406

since 1996 release

Repair and operation of the car

Peugeot 406
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engine
+ 4. Cooling systems, heating and ventilation
+ 5. Fuel system
+ 6. System of ignition
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Brake system
+ 11. Suspension bracket and steering
+ 12. Body
- 13. Electric equipment
   13.1. Technical data
   13.2. Detection of not closed chain
   13.3. Safety locks and relay
   13.4. Switches
   13.5. Bulbs of external lighting
   13.6. Lighting lamps of salon
   13.7. Devices of external lighting
   13.8. Adjustment of light of headlights
   13.9. Combination of devices
   13:10. Multipurpose display
   13:11. Lighter
   13:12. Hours
   13:13. Sound signal
   13:14. Screen wiper lever
   13:15. Engine of a screen wiper and draft
   13:16. Back screen wiper
   13:17. Windscreen washer
   13:18. Automobile radio tape recorder
   13:19. Column (dynamics)
   13:20. Antenna
   13:21. Control system cruise control
   13:22. Anticreeping system and immobilizer of the engine
   13:23. Electric units of forward sitting
   13:24. Safety cushion
   13:25. Safety cushion elements
   + 13:26. Electric circuits
+ 14. Main malfunctions


13:15. Engine of a screen wiper and draft

Removal and installation

1. Remove the negative plug from the accumulator.
2. Remove the screen wiper lever.
3. Unscrew a lock nut.
4. Remove the left and right plastic covers of system of ventilation from the windshield basis.
5. Remove the left and right elements of system of ventilation in the lower part of a windshield for access to the screen wiper engine.
6. Disconnect the electric socket located on wires of power supply of the engine of a screen wiper.
7. Unscrew nuts and bolts (are specified by shooters a photo at the left) fastenings of a screen wiper and take a screen wiper (a photo on the right).
8. Remove the rubber damping laying from a screen wiper.
9. If necessary note the relative provision of a shaft of the electric motor and a crank, unscrew a nut (1) and remove draft of a screen wiper from an electric motor shaft. Unscrew bolts (2) fastenings of the engine and remove from it drafts.
10. Installation is made in the sequence, the return to removal.

On the homepage